. BUILDING A BETTER TOWER USING KLEENEX and PUFFS tissue BOXES

The Puffs box measures 4 5/8 inches wide by 5 1/4 inches tall. That gives this tower a 4 5/8" Sq Foot print.
Using a 6.5 aspect ratio this requires 5.714 boxes Use 6. 110 / 6 = 18.4 floors per box.
Yes your WTC Tower will be thiner that the real one. Shorter too.
Fold on the 3 red lines.
You may trim these graphics in diferent ways.
NOTE. On the bottom box and the 4 mid section boxes cut to 5 1/2" tall.
Leave the top edge of the paper rising higher than the top of the box.
This allows the next box to fit inside this edge.


TOP SECTION - Print 2 sheets.
Trim to the 5 1/4" box height. Cover the top with white sheet cut to fit.
Soda Straw Antenna Optional.




MID SECTIONS - Print 2 sheets for each box.
Trim each sheet to the 5 1/2" tall = 1/4" taller than box height.
Leave the top edge of the paper rising 1/4" higher than the top of the box.
This allows the next box to fit inside this edge.

Trim one sheet wide enough to fold in the middle and fold at the ends over the edges of the box.
Trim the other sheet at the outer red fold lines and paste its edges over the folded edges of the first sheet.




BOTTOM SECTION - Print 2 sheets for each box.
Trim each sheet to the 5 1/2" tall = 1/4" taller than box height.
Leave the top edge of the paper rising 1/4" higher than the top of the box.
This allows the next box to fit inside this edge.

Trim one sheet wide enough to fold in the middle and fold at the ends over the edges of the box.
Trim the other sheet at the outer red fold lines and paste its edges over the folded edges of the first sheet.




STANDARD WALL UNIT Make 3. Print and trim to fit.


MECHANICAL FLOOR - WALL UNIT (floor 42 or floor 76) Make 1. Print and trim to fit.


Take care and do good work